Meet the EDGEHOG: a 3D-printable, Warthog-inspired case designed for the CORSAIR XENEON EDGE. The case uses two identical printed handle pieces that slide onto the ends of your XENEON EDGE. It also includes left and right feet, which are captured inside the handles when you want to stand the display upright. Notes: Print as two identical handle pieces, plus left and right feet Packs flat for easy storage and transport Secures using two 1/4"-20 screws Recommended screw length: 1/4" or 5/16"—no longer than 8 mm Doubles as a stylish upright stand The EDGEHOG isn’t intended to be a full protective case, it’s primarily a functional accessory with a distinctive look. Complete the look with the FREE BIO GRID Orbital Watch shown on screen! Printable HERE   submitted by   /u/Roricas   to   r/Corsair [link]   [comments]