Just a spec to performance report. Tried Maya today on the following: 3950x 96GB dual channel DDR4 at 3000mhz Rx 7900xtx 24GB + w6800 32GB (56GB together) pcie gen3 nvme drive The Deepseek weights used were the mostly iq2 weights with Q6 ngrams. ~350GB on disk. Dspark left on. I ended up getting wildly varying performance - less due to dspark hits and more due to when I/O was needed. I got peaks as high as 19t/s, usually hovering around 13t/s, then dropping down to 3t/s for a few seconds, then right back up. Average at the end of a long prompt was 9t/s decode. Prefill is ~150 t/s. . Some prompts it rips through at 15 tokens a second, others it will crawl through at 3-5 tokens per second even if it's the same topic. Its very odd and I've been trying quite a few settings to figure it out. The model itself is crazy smart - better than the iq4-xs quant of Qwen3.8-Flash-Next I've been running for certain - but it likes to think A LOT and with the already slow average of 9t/s decode I won't be using it for much outside of chatting even if it is the new best model on my machine.   submitted by   /u/EmPips [link]   [comments]