BCAR Shroud / Mock Suppressor This tube attaches with 2 screws through the furthest away holes in the handguard. Looks cool but kinda plain, I'm hoping more talented modellers can embellish the outer tube with like dimples, ridges, text, etc. https://www.printables.com/model/1854394-hq-e2-bcar-shroud-suppressor-mod 2-Piece Magazine Follower The HQ-E2 bolt hold-open requires the magazine follower to have a magnet positioned about 26mm below the top of the follower. This makes the follower unusually tall and reduces dart capacity by -1 dart in any magazine. My version puts the magnet at the correct position when down to 1 dart or empty, and compresses when the magazine is full, so I can still jam 15 darts into Dragon Claws without using extensions. https://www.printables.com/model/1849185-hq-e2-compressible-2-piece-bolt-hold-open-magazine Enjoy! I haven't touched any 3D modelling since making hacks on Clan Dead Goat so there's a learning curve to get back into the flow.   submitted by   /u/kkibb5s   to   r/Nerf [link]   [comments]