Looking for someone to print a decorative antenna replacement for my 2016 F-250. It's the Convoy/Deathproof duck (Gamebox13's model, CC-BY) on a remixed base that sits on the truck's cowl trim — a 40 mm flange with a peg that drops into the antenna hole and a pocket underneath for a brass threaded insert. I'll handle the insert, stud and install; I just need the prints. Two STLs, same duck, only the insert pocket in the bottom differs (M6 vs M5) — I'd like one of each so I have the one that matches the truck. Each is 73 × 40 × 58 mm, roughly a 3-hour print. ASA strongly preferred since it lives outside in the sun and car washes; PETG is okay, PLA won't hold up. Black filament please — the printed color is the finish, no paint. I'm on the South Shore and happy to meet up, or I'll cover shipping. Files are attached/linked below and full print settings are in my first comment. Thanks! Print settings 100% scale, do not resize — pocket and peg are sized to specific hardware and the hole in the truck Orientation: flange down, duck upright, as the STL is oriented 0.16–0.20 mm layers, 4–5 walls, 5+ top/bottom 30–40% gyroid/cubic infill, but bottom ~20 mm solid (height-range modifier at 100%) — that's the flange, peg and insert pocket Supports needed for the beak and tail; tree supports leave the fewest marks. The vertical hole in the bottom needs none Please leave the pocket in the bottom untouched, I'm epoxying an insert in Black ASA or PETG, no paint or coating — the raw black print is the finished look. Light support cleanup welcome, nothing else needed. https://drive.google.com/drive/folders/1mk3IZYjC0JTuZ26Hr4nWP9xH27bzHVNk?usp=sharing   submitted by   /u/JaizonIzRael [link]   [comments]