Hey there. I started modeling this, but ran into to PC issues. Picture 1 shows the basic files, and they are stacked as they would be assembled, and they are already in the proper proportions (although the tallest piece is probably about 15 inches tall give or take). These are to be printed and glued together, so retaining the symmetry is important. Pictures 2 and 3 show the same files from Picture 1 separated out, front and back. Photo 4 is where things went sideways after attempting smoothing. Photo 5 is the desired outcome. The round piece on the front has already been completed and isn't required. Budget is between 300-400, negotiable. Speed is far more important.   submitted by   /u/Vhaasen [link]   [comments]