Memory prices are at record highs due to demand from the AI sector and are not going to drop any time soon. In fact, the cost of manufacturing memory chips on a per-area basis can be higher than the price of silicon processed using TSMC's N2 and N3 fabrication technologies, which are used to make compute chips, according to an observation made by Kurnal Insights. While the comparison has merit, it has an important caveat. DRAM Wafer price is more expensive than TSMC N3 Wafer Price pic.twitter.com/uWqizOZ6iGSeptember 20, 2026Based on media leaks, Kurnal from Kurnal Insights considers that a 300-mm wafer processed using TSMC's N3 technology costs $20,000, which translates to approximately $0.283 per mm² when the wafer price is divided by its area. For TSMC's N2, the analyst assumes a considerably higher wafer price of $30,000, or around $0.424/mm². These calculations are based on unofficial information and do not account for unusable wafer edges, dicing, test structures, defects, or yield, so they should be viewed as nominal wafer-area prices rather than the actual price of usable silicon. The calculation for DRAM works differently. Kurnal assumes a DRAM price of $1.50 per Gb and then multiplies it by the bit density of different generations. At 0.219 Gb/mm², 1y DRAM works out to $0.329/mm², whereas 1z DRAM with its 0.273 Gb/mm² density reaches $0.410/mm². Finally, 1b DRAM at 0.436 Gb/mm² produces a figure of $0.654/mm², considerably higher than the nominal $0.424/mm² calculated for an N2 wafer. There is an important distinction here. The N2 and N3 numbers represent assumed prices charged by TSMC for processing a wafer, whereas the DRAM figures represent the potential selling value of the memory contained within a square millimeter of silicon, thus illustrating how much revenue a DRAM maker can theoretically get from a given die area at the assumed memory price. Interestingly, Kurnal Insights' $1.50/Gb assumption is almost exactly in line with the current spot price of DDR5 eTT memory. According to DRAMeXchange, 16Gb DDR5 eTT chips carried a session-average price of $24.80 on September 21, equivalent to $1.55/Gb. At that price, 1b DRAM with a density of 0.436 Gb/mm² would be valued at approximately $0.676/mm², just 3% above Kurnal's $0.654/mm² estimate. It goes without saying that producing DDR5 memory is considerably cheaper than making logic chips using TSMC's N3 process technology. However, with DRAM in short supply, memory makers are getting considerably more money for their silicon than they did historically. There are a few important caveats that make the comparison somewhat less straightforward. The calculations do not account for packaging costs, with logic requiring more expensive techniques. Additionally, TSMC manufactures chips on a contract basis, and the actual price of a processed wafer depends on the volumes, customer, and other commercial terms. Thus, comparing estimated TSMC wafer prices with DRAM spot prices is not exactly an apples-to-apples comparison. Even TrendForce notes that DDR5 spot procurement remains limited and transactions are sporadic, which means spot prices do not necessarily reflect the prices at which Micron, Samsung, and SK hynix sell the bulk of their DRAM.Therefore, contract DRAM prices would provide a considerably better basis for an economically meaningful comparison. However, we do not know contract prices, and while they are clearly higher than historical memory prices, they may not be as high as spot prices. To that end, we cannot state for sure that DRAM makers get more money for their wafers than TSMC does for its logic wafers.