I would like the c3 supermini version made. I am using a c6 thought which is slightly shorter. I would like an additional vertical slot on the left hand side where the sgp goes to fit an additional sht, which is the same dimension (make 1 vertical slot the same size as the corner slot) I wont be using it but I would like to keep the C02 monitor and plate compatibility available if it is needed in future versions. the c6 is slightly shorter than the geometry in this version, so the geometry there can be moved a few mm closer towards the usb hole. Also, if a small overhang can be put in just to try and stop the c6 from sliding up and out, snap fit would work as well. finally, add holes for the heat to escape around the c6, on the front, back, and lid, but not on the right hand wall as the right hand wall will be facing up. I can answer specific questions regarding this, I am new to having custom files made. thank you for your time!   submitted by   /u/Parking-Delivery [link]   [comments]