Hi everyone, I bought a very cheap beginner guitar from Amazon, and unfortunately the bridge got ripped off after it was tightened too much. My younger cousin was tightening the strings/bridge too much, and eventually the original bridge broke off. As a temporary fix, I made a DIY/makeshift bridge out of a piece of wood, but it isn't working properly and the guitar is difficult to play/tune correctly. I was thinking about 3D-printing a replacement bridge, but I don't have an STL/3D file for it, and I'm not experienced enough with 3D modelling to design the part myself. I'm attaching: A photo of the guitar with my current makeshift wooden bridge. A picture of the original guitar/bridge from the Amazon listing. I'd really appreciate some help with either: - Finding an existing STL/3D model for this type of guitar bridge, or - Someone helping me create a 3D-printable model based on the original bridge/guitar dimensions. It's a very cheap guitar, so I'm mainly looking for a low-cost DIY solution rather than spending a lot on repairs. If measurements, additional photos, or specific dimensions would help, I can provide them. Thanks!   submitted by   /u/Immediate-Relief-623   to   r/3Dprinting [link]   [comments]