Small desk stand made from scrap: base, two dividers, and a vertical panel that mounts to the drawer box under my desk to hold a closed laptop and its dock. Normally I’d print a dimensioned drawing and take it to the shop. This time I exported the model to my phone as a single file with the dimensions included. At the shop, my scrap wasn’t wide enough for the vertical panel. After another look at the model I realized the panel didn’t need the full width, so I cut it narrower. Back home, I updated the model to match the as-built, using a photo of the actual scrap as the texture. The video shows the SketchUp model, the same model in AR on the desk, and the real unit installed. The cat showed up uninvited for final inspection. Disclosure: I make the plugin I used for the export (ModelLink 3D Studio, the Print to p3DF command). Happy to answer questions about the workflow either way.   submitted by   /u/modellink3d   to   r/Drafting [link]   [comments]