I'm hoping to find someone to help me with a problem I've encountered with my Tineco Purecycle Cordless vacuum. I freaking love this vacuum, but I've noticed a pesky design flaw (at least in my opinion). The exhaust port on the right side of the vacuum puts out a pretty strong stream of air. My problem pops up when I'm using the base without the long stick attachment to clean a small space, like a shelf or corner. I specifically have a LOT of house plants and different shelving throughout my house. When I go to use the vacuum (sans the extension) with just the small angled attachment, the air it puts out basically blows all the dirt around because of where the exhaust comes out. What I'm hoping to find/create is some sort of clip or attachment that would allow me to direct the air either upwards, or straight back to me (maybe with a slight upward angle?). I have access to a 3D printer, but the owner doesn't design/create parts. We are both beginners, so any help or guidance you have would be amazing. Here is all the info I have: **Handheld section:** Tineco Purecyclone, iLoop Model #: VS200200US Voltage: 25.2v **Battery info** (maybe to help verify exact model type?) Model #: ZB2377-7S1P-01A Plants and dirt in the background of the pictures are why I want this part; everything just blows around in these close quarters. Note* the catchment bin is not attached in the photos I've shared (I was cleaning it separately). Let me know if you need to see it.   submitted by   /u/Positive-Ad-5028 [link]   [comments]